g
Printer Friendly Version

editor  
BellaOnline's Tatting Editor
 

The Classic Wheel


It is never too early to begin your tatted entries for the State and local fairs. To inspire you here is a vintage edging. This classic wheel edging earned Mabel Stanley the $1 prize as reported in the April 20, 1919 newspaper in Cuyahoga Falls [Ohio.] Directions have been modernized for tatting convenience.

Heading is a line of opposing rings joined at the sides.
R 1: 4 - 4 - 4 - 4 clr. rw
Leave bare thread space of 3/8"or 1 cm
R 2: 4 - 4 - 4 - 4 clr. rw
Leave bare thread space of 3/8"or 1 cm
*R 3: 4 + (join to last picot of ring 1) 4 - 4 - 4 clr. rw
Leave bare thread space of 3/8"or 1 cm
R 4: 4 + (join to last picot of ring 2) 4 - 4 - 4 clr. rw
Leave bare thread space of 3/8"or 1 cm
Repeat from *for desired length

Medallion (Tatted Wheel)

Leave a long tail as the round center ring is tatted first; the 12th picot becomes a mock picot and the long tail is used to create a split ring to climb into the next row of alternating large and small rings.

Ring of 11 picots separated by 2 ds. Close ring and use tail to create mock picot. Continue to use the long tail to tat one split ring:

Split Ring 6 / 6 (Use the shuttle to begin the ring and tat 6 ds. Next bring up the long tail and use it to wrap 6 ds. Use shuttle to close ring.) DNRW

Leave bare thread space of 3/8"or 1 cm
Large ring 4 - 2 - 2 - 2 - 2 - 2 - 2 - 4 clr rw
Leave bare thread space of 3/8"or 1 cm
*Small ring 6 + (join to picot of center ring) 6 clr rw
Leave bare thread space of 3/8"or 1 cm
Large ring 4 + (join to last picot of previous lg ring) 2 - 2 - 2 - 2 - 2 - 2 - 4 clr rw
Leave bare thread space of 3/8"or 1 cm

Repeat from * around, joining two of the large rings to the heading by the center picot. Use magic thread trick to hide both the shuttle tail and the long tail in the last ring.

Join next medallion to the first medallion by two large rings also as well as joining to the heading. Larger version of original is available here: http://www.georgiaseitz.com/bella/mabelstanleyprizeedging.jpg












Example of round center ring, mock picot and climbing out with split ring.






Example of a similar wheel but with different ds count.







An oft-used pattern it has many variations.
From cuff and collars....






...to handkerchief edgings...






...to flowers.



clr = close ring
DNRW = do not reverse work
ds = double stitch
+ = join
- = picot
R = ring
RW = reverse work
/ = slash mark indicate the point at which you switch from shuttle 1 to shuttle 2 to make a split ring.

Tatting Site @ BellaOnline
View This Article in Regular Layout

Content copyright © 2013 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.



| About BellaOnline | Privacy Policy | Advertising | Become an Editor |
Website copyright © 2014 Minerva WebWorks LLC. All rights reserved.


BellaOnline Editor