Beaded Bracelet By Dagmar Pezzuto
Beaded Bracelet Hanging Cluny
By Dagmar Pezzuto © 2018
DS = double stitch
R = ring
CH = chain
cl = cluny
hcl = hanging cluny
+ = join
- = picot
-- = long picot
clr = close ring
RW= reverse work
CTM = continuous thread method
1 shuttle, 1 sewing needle
Small beads and a slightly larger bead
This pattern is done in a single round. Start with CTM
R1 = 7DS ?V 7DS. Clr RW
CH1 = 6DS ?V 6DS +(join to R1 adding 3 smaller beads) 5DS -- (long picot) 1DS -- (long picot) 4DS + (join to base R1) RW
CH2 = 8DS
Hcl = 16 passes
CH3 = 8DS
The second ring joins to the first ring of to the long picots on which you have placed one of the larger beads.
Notes: The rings may be tatted as a ring surrounded by a chain or as an onion ring set.
The small beads need to be placed on the shuttle thread or you may make the long picot then place the three beads into position and then make the join to the inner ring.
Repeat as many as needed for the desired size.
Please review the basics of the hanging cluny with Ruth Perry's tutorial. The link is listed on this page.
How to make the onion ring join.
The onion ring join makes it possible to create the look of a ring surrounded by a chain but using only one shuttle.
Editor's Picks Articles
Top Ten Articles
Content copyright © 2019 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.