For every pound to pound and a half of meat use the following ingredients and add them to your meat according to the instructions below.
¼ tsp salt
1 tbsp sherry, rice wine vinegar, or soy
1 egg white
1 tbsp cornstarch
½ tbsp oil
- Begin by removing all the fat from the meat and cutting it into the sized pieces as specified in the recipe. Then place the meat into a container with a tight fitting lid.
- Sprinkle in the salt and mix it in thoroughly with your hand. Feel to make sure that each piece is coated.
- Add the sherry, rice wine vinegar, or soy depending on what your recipe calls for. If the recipe does not state a particular marinade then just use sherry. Mix it in thoroughly.
- Add the egg white and gently mix it in coating each piece. Make sure not to froth the egg, otherwise the meat will turn out rubbery after cooking.
- Sprinkle in the cornstarch while mixing it with your hand.
- Add the oil and stir to coat.
- Cover and let the meat marinate for 30 minutes at room temperature.
Boiling Method
- Bring a pot of water with a tablespoon of vegetable oil to a boil.
- Once the water boils, add the meat and let it cook for just 1 minute.
- Remove the pieces quickly with a slotted spoon and set them aside to be used in your stir fry. Try not to get any of the egg that may have floated to the top in with your meat.
- In a wok, heat enough vegetable oil to cover all of your meat. We want each piece to be submerged in oil. Heat the oil on medium. We don’t want the oil so hot that the meat sizzles. If the oil is too hot it will overcook the meat and make it tough.
- Once the oil is heated, add the meat and lightly stir with either a fork or chopsticks for just 30 seconds. Cook the meat in batches so that it does not overcrowd the wok. Again, we don’t want the meat to sizzle; otherwise it will be overcooked in the final dish.
- Place the meat on a plate to be used in your stir fry. Reserve the oil for future use.