NH Youngburg Pattern #1
One Thread Edging No. 1 Pg. 1 New model tatted by Shanan Strode
Wind one shuttle with size 70 thread. (Adjust the length of the picots and the length of the bare thread spaces if using any other size of thread.)
R 6 - 6 clr rw. Leave 1/4" bare thread space.
R 6 - 3 - 3 clr. Leave no bare thread space.
R 3 - 3 - 6 clr rw. Leave 1/4" bare thread space.
A. R 6 - 6 clr rw. Leave 1/4" bare thread space.
B. R 6 + (join to previous ring C) 3 - 3 clr. Leave no bare thread space.
C. R 3 - 3 - 6 clr rw. Leave 1/4" bare thread space.
As noted above the length of the picot will vary by the size of the thread and the tension of the individual tatter. One method is to measure the length of thread needed for a picot by the width of a double stitch. Care should be taken to consider if the original measurement suggestion was for the picot in the open or closed position.
You Should Also Read:
NH Youngburg Pattern #2
NH Youngburg Pattern #8 & 9
Editor's Picks Articles
Top Ten Articles
Content copyright © 2018 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.