Rose Brooch by Jeanne Lugert
Jeanne Lugert's Rose Brooch
If you tatted the rose earrings by Jeanne Lugert last week, you will be pleased to find this matching brooch pattern, also from the files of the Online Tatting Class.
R = ring
CH = chain
SR = split ring
CL = close ring
+ = join
± = make a picot on the first repeat and join there on the following repeats
W = split chain or wrap stitches
Model shown used size 20 thread in green.
There is one split ring in the pattern. Wind 2 shuttles or you can simply open the ring extra wide and do the wrapping of the single split ring using the ball of thread with a rubber band around it.
#1 R 2 - 2 - 2 - 2 clr leave a 4 DS space of thread (about ¼")
#2 R 3 + 3 - 3 - 3 clr leave space
#3 R 4 ± 4 - 4 - 4 clr leave space
#4 R 3 + 3 - 3 - 3 clr leave space
#5, 6, 7 R 2 + 2 - 2 - 2 clr do not leave a space of thread. You are now headed back toward the beginning.
W 4 ds over the space between rings 5 & 4. (If you do not wish to do wrap stitches, you may simply join to the thread space or leave another ¼" space and then do a join in the bottom of ring 4.)
#8 R 3 + 3 - 3 - 3 clr
W 4 DS
#9 R 4 + 4 - 4 - 4 clr
W 4 DS
#10 R 3 + 3 - 3 - 3 clr
W 4 DS
#11 R 2 + 2 - 2 - 2 clr do not leave space nor do any wrapping.
#12 SR 2 + 2 / 2 + 2 leave a mock picot and reverse work.
Insert magic thread into next chain.
CH 9 shuttle join to R 12
CH 6 shuttle join to R 11 (repeat 3x)
CH 9 join to center picot of ring 6
CH 9 join to R 5
CH 6 join to R 3 (repeat 3x)
Insert magic thread in next chain.
CH 9 join to beginning mock picot, tie cut and hide ends.
Many thanks to Jeanne for sharing her pattern with the Online Tatting Class and tatters everywhere.
You Should Also Read:
Planning for the End
3-D Rose Earrings
Editor's Picks Articles
Top Ten Articles
Content copyright © 2019 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.