Needle Tatting a Wide Picot

Needle Tatting a Wide Picot
Here is a challenge for the needle tatter, the Wide Picot.


Here is a challenge for the needle tatter, the Wide Picot.


1.Thread needle and prepare to wrap the ring/chain. For practice wrap 4 ds.
2.Next wrap an extra long, really wide picot.



3.Prepare to wrap the next double stitch.
Form the loop for the first half stitch but do not place it on the needle yet.




4.Pull this loop up through the wide picot.



5.Next slip the loop over the point of the needle.
Remove some slack but not all.



6.Form the loop for the second half stitch and slip it onto the needle.



7.Remove the slack. Check to be certain you have the front side of the ds in the proper position.
I found that it was easy to mix up the first and second half stitch when wrapping this wide picot.



8. Continue to wrap the ds, first bringing the first half stitch loop up though the wide picot until you have reached the width desired.


8. Continue to wrap the ds, first bringing the first half stitch loop up though the wide picot until you have reached the width desired.

Then return to the normal wrapping of the ring/chain and remove from needle.




You Should Also Read:
Needle Tatting a Ring
Needle Tatting Practising the Double Stitch

RSS
Related Articles
Editor's Picks Articles
Top Ten Articles
Previous Features
Site Map





Content copyright © 2018 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.